Instant Mold Tutorial

dusktiger at 00h00
14
Nov
2011
Instant Mold Tutorial

So some of you may have noticed Darren's stocking this stuff on the shelves now:


i bought a package to see how it works, and i can tell you if you want to make extra bits, like insignias, etc for your army, such as say....additional ultra marine or salamander symbols off a Forge World door to put on a drop pod, or on the roof
About
This topic belongs to the forum
  • Numbers of topics : 2430
  • Numbers of messages : 21411
  • Numbers of users : 141
  • Numbers of points : 1462
Similar topics
I recently bought some new modelling tools. And here they´re. Instant Mold Very good to copy small symbols, icons and bits in low number. Sakura micron Pen Very good for pre-painting the heraldic of our GK. Circlecutter Good tool for cutting
I only know this works for arcemu, any other emulator i have no idea if it works. Go into your con-fig files. (ex.Repack/ArcEmu/Config) open the optional.conf using notepad, and go down until you see start level, something level, and level cape. If the
This tutorial will show you how to quickly and easily create brick bases for an army using greenstuff or any other sculpting putty. I'll show the steps for building a simple press mold to quickly make nice bases. The final
http://www.youtube.com/watch?v=gJLIiF15wjQ
Anyone have some great instant plays? I have been watching Blue Mountain State. Funny show if not a bit over the top.
Forums from same category
  • Forum dedicated to Flames of War table top war gaming in Saskatoon. A place for discussion and finding games within the Saskatoon gaming community

  • Free forum : Warhammer 40k forum for Nerdtopia club.

  • Wargaming

  • Brackley gaming club, friendly gaming meets each Tuesday night at Bracklen Leas School from 6pm for the juniors and 7.30pm for adults

  • Aion, Zhentil Keep. Zhentil Keep. World Of Warcraft Zhentil Keep

  • Free forum : A message board for warhammer fantasy battle in Saskatoon

See also
more_less
Informations

2 Replies For the topic :
"Instant Mold Tutorial"

This topic has been viewed 352 times.

Last message :
14/11/2011 at 00h00 by "dusktiger"